Brand: MySpool

Be alerted away from home or business
MySpool Power Failure Detector is a smart device that sends an alert when power failure is detected. An alert is also sent when power comes back on. That alert is a message, either via email or text, or both. Power Failure Detector is configured to use your WiFi (see Important Note below). The setup takes a few minutes with a smart phone or a laptop.

No Hub Required
Each Power Failure Detector works independently with your Wi-Fi network. Multiple devices can be placed in different locations throughout your home or business. Your notifications will include your text for each device that you specify in the device configuration.

No Fees
There are no fees for using MySpool Power Failure Detector for any notifications.

Flexible design
MySpool Power Failure Detector comes with an extra long 6 foot power cord connected to an enclosure with a transmitter. Power Failure Detector will ignore short duration power fluctuations of less than 2 seconds so that no unnecessary notifications are sent. Note that since no device is permitted to send more than 1 alert per minute, your POWER ON notification may be delayed by up to 1 minute if power comes back on immediately. Each device requires 3 AAA batteries, included. The batteries should last 5 years or more assuming average power outages and fluctuations

• The original power outage alert system: This device, built by Bell Labs engineers to protect their homes, notifies of power outages.
• Security away from home: You will never again have to ask, "Is my power out?" or "Is there a power outage in my area?"
• Immediate detection: You will be alerted of a power failure in your home or business within seconds of the event. You will receive separate alerts for power outages and power restoration.
• WiFi-enabled: Connect the MySpool Power Failure Detector to your home WiFi to begin receiving text messages, emails, or push notifications during power failures and power restoration.
• Multiple phone numbers and email addresses: Add 2 phone numbers and up to 5 email addresses per device for seamless notifications to multiple people-keep everyone who needs to be in the know!
• Monitor outlets for outages and GFI shut-off: The alert message includes a device description to identify the device's location, e.g., freezer alarm or garage GFI outlet.
• Cloud-based remote configuration: You can update, add, and remove emails and phone numbers from wherever you are. No hub is required, and it can be configured remotely without being near a physical device. Other devices require you to make changes with the device in hand. All MySpool products are cloud-based and give you the power and flexibility to make updates from wherever you are.These are the only devices designed for fleet management from the ground up.
• 2.4 GHz WiFi access during a power outage is required; please check before ordering.
• MySpool Monitoring included: This device sends daily connectivity check-ins to your device to verify internet connectivity. If the check-in fails, you will receive a "check WiFi" notification via email and SMS.
• No fees or subscription costs. Multiple phone numbers and email addresses are supported. MySpool devices are designed only to use the internal AAA batteries to send Power OFF notifications. They should last seven or more years, and notices will be sent with reminders and instructions on how to replace them. Never worry about a power failure at your home or business again.